Troubleshooting; Restoring Factory Default Settings - Esoteric G-02 Manual Del Usuario

Troubleshooting

If you experience a problem with the unit, please take a moment to
review the following information before requesting service.
If it still does not operate correctly, contact the retailer where you pur-
chased the unit.
The power will not turn on.
e Check that the power cord is plugged into a working power outlet.
e Check that the power cord is properly connected to this unit.
The clock output is not synchronizing another device.
e Confirm that the clock being output is supported by the device
connected to this unit. (Select a clock frequency that the connected
device can use.)
The input and synchronization of clock signals might vary according
to the device. Refer to the owner's manual of each device for how to
connect and set them.
The desired frequency cannot be selected when pressing the A,
B and C buttons.
e Set the reference frequency with the frequency mode setting
(FREQ) first, and then use the A, B and C buttons (see page 14).
16

Restoring factory default settings

Settings are retained even after the power cord has been disconnected.
If you have made changes using the settings menu, and want to
restart with the original settings, restore the unit to the default factory
settings as follows.
Turn the unit off.
1
If the unit is on, press the POWER button to turn it off and wait for
more than 30 seconds.
Press the POWER button while holding down
2
the MASTER/MENU button.
0 Release the MASTER/MENU button when the unit turns on
and the display lights.