Echo PW-3600 Manual Del Operador página 13

ASSEMBLY
Connecting the High Pressure Hose to the
Trigger Handle
See Figure 6.
 Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
 Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
Connecting the High Pressure Hose to the
Pump
See Figure 7.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
 Pull back and hold the collar on the pump. Insert the inlet
coupler on the end of the high pressure hose into the
collar.
 Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
Connecting the Garden Hose to the Pressure
Washer
See Figure 8.
NOTICE
Always observe all local regulations when connecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drink-
ing water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
DO NOT OVERTILT THE UNIT!
The water supply must come from a water main. NEVER use
hot water or water from pools, lakes, etc. Before connecting
the garden hose to the pressure washer:
 Run water through the hose for 30 seconds to clean any
debris from the hose.
 Inspect the screen in the water intake.
 If the screen is damaged, do not use the machine until
the screen has been replaced.
 If the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
 Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
NOTE: There must be a minimum of 10 feet (3 m) of un-
restricted hose between the pressure washer intake and
the hose faucet or shut off valve (such as a "Y" shut off
connector).
 With the hose faucet turned completely off, attach the
end of the garden hose to the water intake. Tighten by
hand.
Do not run the pressure washer without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure the
hose is not being restricted by tires, rocks, or any other
objects that may lessen or prevent water flow to the
pressure washer.
English
NOTICE
9