Using The Device; Handling Electrical Cables - Waeco CA-800-DAF Instrucciones De Instalación

CA-800-Install.book Seite 23 Mittwoch, 4. Juli 2007 3:05 15
CoolAir
1.1

Using the device

Only use the roof air conditioner for the purpose specified by the manu-
facturer and do not make any alterations or structural changes to the
device.
Only operate the roof air conditioner if you are certain that the housing
and the cables are not damaged.
The roof air conditioner must be installed safely so that it cannot tip over
or fall down.
Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with the
risks involved and the relevant regulations.
Do not use the roof air conditioner near flammable fluids or in closed
rooms.
Do not reach into air grilles or ventilation nozzles or insert any foreign
objects in the system.
Do not undo the upper cover of the roof air conditioner in the event of a
fire. Use approved extinguishing agents instead. Do not use water to
extinguish fires.
Switch off the roof air conditioner before you use automatic washing
equipment (car washes, etc.) to clean the car!
Please ask your vehicle manufacturer if the height entered in your vehi-
cle documents needs to be altered due to the extra height of the air con-
ditioning roof unit (extra height XF105 = 195 mm, XF95 = 209 mm).
Disconnect all connections to the battery when carrying out work on the
device!
Always manually drain the condensation from the system before
maintenance or tilting the cab (see the section on draining the
condensation in the operating manual for the CoolAir CA-800).

1.1.1 Handling electrical cables

Use cable ducts to lay cables through walls with sharp edges.
Do not lay loose or bent cables next to electrically conductive materials
(metal).
Do not pull on the cables.
Attach and lay the cables in such a manner that they cannot be tripped
over or damaged.
The electrical power supply may only be connected by a qualified elec-
trician.
Fit a fuse of at least 25 amps to the connection with the vehicle's power
supply.
Never lay power supply lines (battery leads) in the vicinity of signal or
control wires.
All manuals and user guides at all-guides.com
Safety instructions
23