Start And End Configuration Mode; Menu Level 1: Set Temperature - Waeco CA-800-DAF Instrucciones De Instalación

CA-800-Install.book Seite 33 Mittwoch, 4. Juli 2007 3:05 15
CoolAir

6.3.1 Start and end configuration mode

The adjustable parameters can be altered in edit mode:
➤ With the system switched off, press the ON/OFF button (see fig. 10 on
➤ Additionally press the operating mode button (see fig. 10 on page 6,
➤ Let go of the ON/OFF button.
➤ Hold the operating mode button pressed until the LED compressor
✓ You are now in configuration mode.
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode and switches off.
➤ Press the ON/OFF button to quit configuration mode.

6.3.2 Menu level 1: Set temperature

The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
➤ Use the + or - buttons (see fig. 10 on page 6, Pos. 6 and 7) to select
✓ The digits in the display flash until the parameter you enter is con-
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 1 and can use the + and - buttons to switch
All manuals and user guides at all-guides.com
page 6, Pos. 1) and hold it down for 2-4 seconds.
Pos. 4) within these 2-4 seconds.
flashes.
menu level and the second and third show the parameter which can
1.17
be set – for example,
mode" on page 33).
menu level and the second and third show the parameter which can
be set.
change the parameter.
the temperature (in °C) with which the system starts.
firmed.
confirm your entry.
between menu levels.
for menu level 1 and a set value of 17 °C.
Installation
33