Transport, Packaging And Storage; Box Contents; Packaging; Storage - Heiniger Xperience Traducción Del Manual Original

6 Transport, packaging and storage

6.1 Box contents

1 clipper
1 pair of clipping blades
1 special screwdriver
1 bottle of special lubricating oil
1 cleaning brush
1 case for transport and storage
1 operating instructions
NOTE
► Check to ensure the completeness of the contents and that there is no damage.
Please report incomplete package contents or any apparent damage immediately to
your supplier/dealer.

6.2 Packaging

Only environmentally friendly materials are used for packaging.
The return of the packaging saves raw materials and reduces the volume
of waste. Dispose of packaging materials that are no longer needed in
accordance with locally applicable regulations.

6.3 Storage

Store the clipper and its accessories under the following conditions:
• Do not store out of doors.
• Store in a dry and dust-free area.
• Protect from direct sunlight.
• Avoid mechanical shock and vibration.
• Storage temperature: 0 to 40 °C.
• Relative humidity: max. 90%.
• If stored for longer than three months, check the general condition of all parts regularly.
• When not using the clipper, store it in the case making sure it is well cleaned, lubricated
and that the clipping elements are not spring loaded (risk of corrosion).
28
All manuals and user guides at all-guides.com

7 Operation

7.1 Requirements at the place of use

• Observe the operating instructions (see chapter Specifications).
• Outdoor electrical sockets must be fitted with a residual current device (RCD).
• The work place must have adequate lighting.
• The electrical socket must be easily accessible so that the device can be quickly
disconnected from the mains.
• The cable must not be taut or kinked.
• Make sure there is adequate ventilation.

7.2 Adjusting the clipping pressure

Fig. 3
► If the clipping pressure is too low, hair can gather between the clipping blades. This
results in a poor clipping quality. In this case, clean the clipping blades as described in
chapter 7.7.
Cattle clipper Xperience Cattle clipper Xperience
Set the clipping pressure as follows before you start
clipping:
Turn the adjusting knob in the direction of the
‹
arrow until you feel resistance.
Turn the knob another 1/4 turn in the direction
‹
of the arrow.
If the clipping quality deteriorates, increase the
‹
clipping pressure by turning the adjusting knob
another 1/4 turn in the direction of the arrow.
If this does not produce the desired result, the
blades must be replaced or sharpened.
NOTE
29