3. Mark three holes on wall where screws will be
inserted. (See Figure 3)
NOTE: Place marks for top two holes at top of
the narrow slot of holes.
Figure 3
Mounting
Locations
1.
Insert key into lock opening on front of dispenser
and turn to open cover. (See Figure 5)
Figure 5
2. Insert a roll of jumbo bath tissue onto the arm.
(See Figure 6)
Figure 6
PAGE 2 OF 6
MOUNTING INSTRUCTIONS CONTINUED
LOADING INSTRUCTIONS
Arm
Roll
1-800-295-5510
4. Drill into wall at three marked locations with
appropriate size drill bit. (See Figure 4) Insert wall
anchors if necessary.
Figure 4
5. Hold dispenser over previously drilled holes and
insert top two screws, but do not tighten completely.
Drop dispenser down so screws slide up into narrow
slots and tighten screws completely. Insert bottom
screw.
3. Close lid and begin dispensing. (See Figure 7)
Figure 7
uline.com
0421 IH-5113