Maintenance And Repairs; Disposal; Ec Declaration Of Conformity - Stihl TSA 230 Manual De Instrucciones

23 Maintenance and Repairs

Always remove the battery before carrying out any work on the power tool.
Fault
Light emitting diode on charger
flashes red
1)STIHL recommends STIHL dealers
23 Maintenance and Repairs
Users of this machine may only carry out the
maintenance and service work described in this
user manual. All other repairs must be carried
out by a servicing dealer.
STIHL recommends that you have servicing and
repair work carried out exclusively by an author‐
ized STIHL servicing dealer. STIHL dealers are
regularly given the opportunity to attend training
courses and are supplied with the necessary
technical information.
When repairing the machine, only use replace‐
ment parts which have been approved by STIHL
for this power tool or are technically identical.
Only use high-quality replacement parts in order
to avoid the risk of accidents and damage to the
machine.
STIHL recommends the use of original STIHL
replacement parts.
Original STIHL parts can be identified by the
STIHL part number, the { logo and the
STIHL parts symbol K (the symbol may appear
alone on small parts).

24 Disposal

Observe all country-specific waste disposal rules
and regulations.
0458-707-9821-C
Cause
No electrical contact between
charger and battery
Error in battery
(4 LEDs on battery flash red for
approx. 5 seconds)
Fault in charger
STIHL products must not be thrown in the gar‐
bage can. Take the product, accessories and
packaging to an approved disposal site for envi‐
ronment-friendly recycling.
Contact your STIHL servicing dealer for the lat‐
est information on waste disposal.
25 EC Declaration of Con‐
ANDREAS STIHL AG & Co. KG
Badstr. 115
D-71336 Waiblingen
Germany
declare under our sole responsibility that
Designation:
Make:
Series:
Serial identification num‐
ber:
conforms to the specifications of Directives
2006/42/EC, 2014/30/EU and 2011/65/EC and
has been developed and built in compliance with
Remedy
at temperatures of approx.
15°C to 20 C (59°F to 68°F)
Operate the charger only in a
closed, dry space at ambient
temperatures of +5°C to
+40°C (41°F to 104°F)
Remove battery and reinsert it
Remove the battery from the
power tool and reinsert it.
Switch on the power tool – if the
LEDs still flash, the battery is
faulty and must be replaced
Have charger checked by serv‐
1)
icing dealer
formity
Cordless cut-off
machines
STIHL
TSA 230
4864
English
59