Left Axle
Bracket
PAGE 2 OF 6
ASSEMBLY CONTINUED
Figure 3
Figure 4
Right Axle
Figure 5
Bracket
Figure 6
1-800-295-5510
uline.com
3. Holding the second upright in place, lift, hook and
lock the support beams in place. (See Figure 3)
4. Hook and lock the third support beam to the back
of the two uprights. (See Figure 4)
NOTE: To readjust the level of the support
beams, pull out the locking tab and lift the
support beam up.
5. Attach axle brackets at the desired level. These
attach to the uprights the same way as the support
beams in steps 2-4. (See Figure 5)
NOTE: Make sure each corresponding left and
right axle bracket is locked at the same height
before adding axles.
NOTE: To readjust the level of the axle brackets,
pull out the locking tab and lift the axle
bracket up.
6. Place axles into the slots on the axle brackets.
(See Figure 6).
NOTE: Axles may be placed into any pair of
axle brackets. It is recommended the larger
axles be placed towards the bottom of the
rack if being used to hold large spools.
0621 IH-4544