Canopy Assembly; Blade Assembly - Craftmade LOU52AGV4 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and push
up. Twist canopy to lock. Re-insert screw that was removed
and then tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted holes in
canopy cover with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
*Remember that antenna for remote control receiver must
rest outside of hanging bracket.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate12 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
All manuals and user guides at all-guides.com
page 7
screw
canopy
canopy cover
motor housing
blade attachment
screws and washers
blade arm
lock washers
blade arm
screws
antenna
hanging bracket
screw
blade