Automated Learning Process./ Activating Code; Wall Control Operation - Craftmade LOU52AGV4 Guia De Instalacion

10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car alarms
or security systems. If you find that your fan and light go on
and off without using your remote control, simply change
the combination code in your remote control transmitter
(and wall control). To set the code, perform these steps:
Remove battery cover on back side of remote control
transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same
number sequence used when wiring the wall control in
Section 6 (page 6).
Note: Since this fan comes with a halogen bulb, the
dimmer switch (labeled D and X) has been pre-set to the
"ON" position (D). If you do not wish to have dimming
capability, please move the switch to the "OFF" position
(X).
Install 9-volt battery (included) in transmitter and then
replace the battery cover.
IMPORTANT: Store the transmitter away from excess
heat or humidity. To prevent damage to transmitter,
remove the battery if transmitter will not used for long
periods.
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning
on the wall control, press the "OFF" button, located on the
front of the transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm the
learning process is complete--see Section 13.

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
LIGHT button - turns light ON/OFF when pressed
once; dims light when pressed and held down. Auto
resume capability keeps light at same brightness
level as the last time it was turned off.
All manuals and user guides at all-guides.com
page 9
TRANSMITTER
(back)
dimmer
switch
battery
cover
TRANSMITTER
(front)
dip
switches
battery