Light Kit Assembly (Optional); Important - Craftmade LOU52AGV4 Guia De Instalacion

9. Light Kit Assembly (Optional).

Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
hole in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was previously removed
and securely tighten all 3 screws with Phillips
screwdriver. [Refer to diagram 1]
If you wish to USE the light kit, remove 1 screw
from post located on underside of fitter plate and
partially loosen the other 2 screws.
Connect WHITE wire from motor housing to WHITE
wire from light kit fitter. Connect BLACK (or BLUE)
wire from motor housing to BLACK wire from light
kit fitter. [NOTE: It may be necessary to push back
sleeve on wires to be certain of wire colors.] Be sure
molex connections snap together securely.
Align slotted holes in light kit fitter with loosened
screws in fitter plate posts. Twist light kit fitter to
lock. Re-insert screw that was previously removed
and securely tighten all 3 screws with Phillips
screwdriver. [Refer to diagram 2]
Install one 75 watt max. halogen bulb, type JD E11
(included).
Tip: Do not touch glass portion of bulb with fingers or
hands. Oil from skin can cause bulb to overheat and
go out prematurely. Use cardboard box or foam
wrapping bulb was packed with to layer around glass
portion of bulb.
Locate slots on glass shade and align with nodules
inside light kit fitter. Gently push up on glass shade
and turn to the RIGHT (clockwise)
completely into place. Pull down gently on glass
shade to make sure glass is secured completely.
[Refer to diagram 2]
IMPORTANT: The glass shade must be removed in
order to replace the bulb. When you need to replace
the bulb, please allow bulb and glass shade to cool
down before touching. Keep in mind not to touch
the bulb itself as described above (see "Tip" above)
If you do NOT wish to use the light kit,
on metal cover and align with nodules inside light
kit fitter. Gently push up on metal cover and turn to
the RIGHT (clockwise) until it slides completely into
place. [Refer to diagram 3]
CAUTION: DO NOT INSTALL THE BULB if you do
NOT wish to use the light kit.
All manuals and user guides at all-guides.com
diagram 1
until it slides
diagram 2
nodule
locate slots
slots
diagram 3
page 8
fitter plate
nodule
slots
motor
housing
motor plate
molex connections
motor
housing
fitter plate
molex
connections
light kit fitter
bulb
glass shade
light kit fitter
metal cover