Safety Instructions; Contents Of Package - Carrera RC Nintendo Mario Kart Mini Instrucciones De Montaje Y De Servicio

ENGLISH
tery, only use the detachable supply unit provided with this
toy. Battery chargers used with the toy are to be regularly examined
for damage to the cord, plug, enclosure and other parts, and in the
event of such damage, they must not be used until the damage has
been repaired. The toy is only to be connected to Class II equip-
ment bearing the following symbol.
or
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including inter-
ference that may cause undesired operation.
Changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user's authority to operate
the equipment.
NOTE: This product has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This product generates, uses and
can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If the product does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures :
• Reorient or relocate the receiving antenna.a
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC statement
The device contain license-exempt transmitter(s)/ receiver(s) that
comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. The device must not cause interference;
2. The device must accept any interference, including interference that
may cause undesired operation of the device.

Safety instructions

The Carrera RC vehicle is designed for hobby use only and
A
may only be operated on tracks and in spaces especially in-
tended for this purpose. WARNING! Do not use the Carrera RC
vehicle in road traffic.
Never operate the product on grass surfaces. Do not use the
B
Carrera RC vehicle for transporting goods, persons or animals.
Never use the Carrera RC vehicle outdoors during rain or
C
snowfall. The car must not be run through water, puddles and
snow, and must always be kept stored in a dry place.
Avoid running on courses which are laid exclusively with sand.
D
Do not expose the Carrera RC vehicle to direct sunlight.
E
4
Never subject the Carrera car to repeated changes of load –
F
that means continuously reversing it.
Never throw the car on the floor from a standing position.
G
The Carrera RC vehicle must be inspected before and after
H
operation, each time it is used, to ensure that it has not be-
come disassembled. Any screws or nuts that may have be-
come loosened during operation must be tightened.

Contents of package

1 x Carrera RC Vehicle
1
1 x Controller
1 x USB charger cable
1 x Set of batteries (non-rechargeable)
Charging the rechargeable battery via computer
This toy (vehicle) contains batteries that are non-replaceable.
2
Take care only to charge the LiPo battery supplied with the LiPo
charging unit (USB charger cable) also supplied. If you attempt to re-
charge the battery with any other LiPo battery charger or any other
type of charger, this may result in serious damage. Please carefully
read the previous chapter with warnings and guidelines on the
usage of rechargeable batteries before proceeding. You can re-
charge the rechargeable battery with the respective USB charger ca-
ble from a computer USB port (USB 3.0) or a USB power supply unit
with at least 1A output voltage:
• Connect the USB charging cable with the USB port of a computer.
The LED on the USB charger cable lights green indicating that the
ENGLISH
charger unit is correctly connected to the computer. If you plug in
a car with a discharged battery, the LED on the USB charging
cable lights up red and shows that the car battery is being
charged. The USB charging cable and the charging socket on the
car are designed to make incorrect connection impossible.
• It takes about 30 minutes to recharge a discharged battery (but
NOT a deep-discharged one). When the battery is fully charged,
the LED display in the USB charging cable lights up green again.
Note: When supplied, the lipo-battery is already partially
charged so the first charging cycle may well take less time.
Always recharge the battery after use to prevent its becoming
deep discharged. After use, the battery must be allowed to
cool down for at least 20 minutes before it can be fully re-
charged. Recharge the battery occasionally (suggested every
2–3 months). Supply terminals are not to be short-circuited.
Failure to treat the battery as described above can lead to its
becoming defective. Never leave the battery unattended while
it is being charged.
While charging, the power switch must be in the "OFF" position.
Open the battery compartment with a screwdriver and insert the
3
batteries in the remote control. Ensure the polarity is correct.
1. Switch the car ON at the ON/OFF switch. The LED of the
4
car will flash rhythmically.
2. Switch on the controller. The LED on top of the controller
5
will flash rhythmically. After a few seconds, the LEDs on the
car and on the controller will light continuously, meaning the
bind has been made.
5