Height Adjustment - Nuna aace lx Manual Del Usuario

Seat Adjustment for Seat Bottom
The seat bottom depth can be adjusted for added comfort for the
child. Three position are provided for best fit.
1
- Reach under the front of the seat bottom.
2
- Pull and hold the seat depth adjustment button to adjust the
seating surface in or out as needed for additional thigh support.
(11)

Height Adjustment

1
- Squeeze the head support adjustment lever, then pull up or
push down the head support until it locks into one of the 17
positions. (12)
2
- As the head support is adjusted up, the side wings of the seat
automatically move outward to provide more shoulder room.
Installation using ISOFIX System and
3-point belt or using 3-point belt only
Use of ISOFIX connectors
1
- If required, attach the ISOFIX guides onto the vehicle ISOFIX
anchor bars. (13)
2
- Pull and hold the ISOFIX adjusting button to pull out the ISOFIX
connectors. (14)
3
- Rotate the ISOFIX connectors 180 degrees until they are
pointing toward the ISOFIX guides. (15)
4
- Line up the ISOFIX connectors with the ISOFIX guide, and then
click both ISOFIX connectors into the ISOFIX anchor bars. (16)
Make sure that both ISOFIX connectors are securely attached
to the vehicle's ISOFIX anchor bars. There should be two
audible clicks and the colors of the indicators on both ISOFIX
connectors should be completely green.
Check to make sure the booster is securely installed by pulling
on both ISOFIX connectors.
9 AACE lx instruction
Removing the enhanced child restraint
1
- Press the secondary lock button (17)-1 first follow by the button
(17)-2 on the ISOFIX connectors before removing the booster
from the vehicle seat.
2
- Rotate the ISOFIX connectors by 180 degrees, then pull
and hold the ISOFIX adjusting button to store the ISOFIX
connectors. (18)
Securing your Child
1
- The back of the child restraint MUST fit tightly against the
vehicle seat back as shown (19).
The front of child restraint MUST NOT hang over the front of
vehicle seat.
DO NOT use a child restraint when vehicle seat back is reclined
beyond the recline position (20).
2
- Pull the vehicle safety belt and route it through the belt path,
and then buckle it up. (21)
Could also be installed by using 3-point belt only.
Position vehicle's shoulder belt through the shoulder belt guide
shown in (21)-1.
DO NOT position vehicle lap belt over the armrests. It must
pass under the armrests.
Make sure the vehicle shoulder belt is routed completely
through the shoulder belt guide as shown in (21)-2.
The child restraint cannot be used if the vehicle safety belt
buckle (female buckle end) is too long to secure the booster
properly. (21)-3
After your child is placed in this child restraint, the vehicle
safety belt must be used correctly, and ensure that any lap
strap is worn low down, so that the pelvis is firmly engaged.
The correct head support height is obtained when the bottom
of the head support is even with the top of your child's
shoulders as shown in (22) and the vehicle belt must be
positioned in the green zone as shown in (23).
AACE lx instruction 10