Merik SECURITY + 511MM FS2 Manual Del Propietário página 10

ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLY
Assemble the T-Rail and
Attach the Cable Pulley Bracket
To avoid installation difficulties, do
not run the garage door opener until
instructed to do so.
1. Place the 3 T-rail sections on a flat
surface for assembly. The end sections
are identical. Make sure the "arrow label"
on the center section is pointing in the
direction shown in the illustration.
2. Connect the center section and the 1/4"
lock nuts to the end sections from the
same side, as shown.
NOTE: If T-rail is not assembled exactly as shown,
trolley will not travel smoothly along length of rail or it
will hit against nuts.
3. Insert the carriage bolts from the opposite side of the
end sections. Tighten the nuts. When assembled, T-rail
has a front-to-back position as shown.
4. Position the cable pulley bracket on the front end of the
T-rail as shown. Fasten securely with the hardware
provided.
NOTE: When tightening the bolts be sure to keep
bracket parallel to the rail. Otherwise, the rail may bow
when the opener is operated.
Rail
(End Section)
Rail connects to
opener at this end.
Brace
Square Carriage
Bolt Holes
HARDWARE
SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
1/4'' Lock Nut
Brace
Rail
(Center Section)
Hex Bolts
Hex Bolts
5/16"-18x7/8"
5/16"-18x7/8"
Tuerca de 1/4"
10
Carriage Bolts
Lock Nut
1/4"-20x1/2"
1/4"-20
Lock Washer
Nut
5/16"
5/16"-18
11 mm Socket Wrench
Cable pulley bracket
attaches to this
end of rail.
Rail
(End Section)
AWAY FROM
OPENER
Carriage Bolt
1/4"-20x1/2"
El sostén de la polea
del cable se fija a este Cable Pulley
Cable Pulley
Bracket
extremo del riel en "T".
Bracket
Lock Washer
Lock Washer
Riel en "T"
5/16"
5/16"
(Sección Extrema)
Nut
Nut
5/16"
5/16"
13 mm Socket Wrench