Install The Door Control - Merik SECURITY + 511MM FS2 Manual Del Propietário

INSTALLATION STEP 6

Install the Door Control

Locate the door control within sight of the door at a
minimum height of 1.5 m where small children cannot
reach, and away from all moving parts of the door and
door hardware.
1. Strip 11 mm of insulation from one end of the bell wire.
Connect it to the two screw terminals on the back of the
door control by color: white wire to 2 and white/red wire
to 1.
2. Remove the cover from the Lighted Door Control.
Fasten the Lighted Door Control Button securely with
6ABx1-1/2" screws. If installing into drywall, drill 5/32"
holes and use the anchors provided.
3. Run the bell wire up the wall and across the ceiling to
the motor unit. Use insulated staples to secure the wire
in several places. Do not to pierce the wire with a
staple, creating a short or open circuit.
4. Receiver quick-connect terminals and the antenna are
located on the back panel of the motor unit. Position the
antenna wire as shown.
5. Strip 11 mm of insulation from end of bell wire. Connect
the bell wire to the quick-connect terminals as follows:
white to white and white/red to red.
NOTE: When connecting multiple door controls to the
opener, twist same color wires together. Insert wires into
quick-connect holes: white to white and red/white to red.
6. Use tacks or staples to permanently attach the
entrapment warning label to the wall near the door
control, and the manual release/safety reverse label in
a prominent location on the inside of the garage door.
WIRING INSTRUCTIONS FOR ACCESSORIES
The Protector System™: To opener terminals: White to
White and Black to Grey.
Outside Keylock Accessory connections: To opener
terminals: Red/white to Red and White to White.
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is NOT connected BEFORE installing door
control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing
garage door:
• Install door control within sight of garage door, out of reach
of children at a minimum height of 1.5 m, and away from ALL
moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing garage door.
Bell Wire
-2
Lighted Door
-1
Control Button
Terminal Screws
Lighted
Door Control Button
22
HARDWARE SHOWN ACTUAL SIZE
Screw 6ABx1-1/2"
Lighted Door Control Button
Quick-Connect Terminals
Door Control
Connections
Strip wire 7/16" (11 mm)
Bell Wire
Insulated
Drywall Anchors Staples
To release or insert wire,
push in tab with screwdriver tip
Red White Grey
7/16" (11 mm)
9
1 9 1
7 3 7 3
5 5
KG KG
Back Panel
Antenna