Ryobi RP4020 Manual De Utilización página 7

GB
FR DE ES
SPECIAL SAFETY RULES
C AT I I I - M e a s u r e m e n t c a t e g o r y I I I i s f o r
Q
measurements performed in the building installation.
Examples are measurements on distribution boards,
circuit breakers, wiring, including cables, bus-bars,
junction boxes, switches, socket-outlets in the fixed
installation, and equipment for industrial use and
some other equipment, for example, stationary motors
with permanent connection to fixed installation. Do not
use the meter for measurements within Measurement
Categories IV.
Use the proper terminals, function and range for your
Q
measurements.
Before measuring current, check the meter's fuses
Q
and turn off power to the circuit before connecting the
meter to the circuit.
Before rotating the mode selection dial to change
Q
functions, disconnect test leads from the circuit under
test.
Be sure the test leads and switch are in the correct
Q
position for the desired measurement.
Never measure resistance in a circuit when power is
Q
applied.
Never touch the probes to a voltage source when the
Q
test leads are plugged into the 10A or 400mA input.
Before use, verify the meter's operation by measuring
Q
a known voltage.
To avoid possible damage to the meter or to the
Q
equipment under testing, follow these guidelines:
• Disconnect circuit power and discharge all high-
voltage capacitors before testing resistance,
continuity, capacitor or diode.
• Before measuring current, check the meter's fuses
and turn power OFF to the circuit before connecting
the meter to the circuit.
Do not charge the product in a damp or wet
Q
location. Following this rule will reduce the risk of
electric shock.
SERVICE
Q Have your battery product serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the battery
product is maintained.
SPECIFICATIONS
Voltage
Display
Max. LCD reading
IT NL PT DK SE
4 V
3 3/4-digit LCD
3999
FI NO RU PL CZ
English
Measurement category
Maximum Voltage
Maximum Current
Sampling Rate
IP Rating*
Operating Temperature
Temperature Coefficient
Storage Temperature
Operating Altitude
*IP Rating: Specifies the environmental protection the
product enclosure provides. An IP Rating of 54 denotes
protection against harmful deposits of dust and protection
against water sprayed from all directions. The water
resistance rating applies only when the battery cap is
installed.
MODEL
RP4020
DESCRIPTION
1. Digital LCD display
2. Mode selection dial
3. Built-in probe storage
4. Kick stand
5 . Convenience hook
6. Function buttons
7. 10A Jack
8. COM Jack
9. Alligator clips
10. Backlight button
11. Probe cover storage
12. Red and black leads
13.
14. Battery pack
15. Battery cover
16. Screws
17. Probe storage
18. Plug-in jacks for test leads
19. Relative mode indicator
20. AUTORANGE mode indicator
21. DATA HOLD mode indicator
22. Alligator clip opening
23. Alligator clip cover
24. Probe
25. DC Voltage
3
HU RO LV LT EE
CAT III
600 V
10 A
2~3 times/sec
54
0°C ~ 35°C, <75%RH
0.2 x (specified accuracy)/°C
(<18°C or >28°C)
-10°C ~ 60°C, <85%RH
0 to 2000 meters
BATTERY PACK
AP4001
A/mA Jack
HR SI SK GR TR
COMPATIBLE
CHARGER
AP4700