Zuvo Water Purator Manual Del Propietário página 6

6. Rotate top cap to
expose filter cover.
7. Pull out filter by
pulling straight up
on the lamp.
8. Prior to installing
new filter, wet lower
O-ring with water to
allow the filter to
slide on easier, and
then simply reverse
the above steps to
re-seal the unit.
WARNING
Run cool tap water through the unit for 5 minutes
to flush the new filter before use. Never flush or
operate the unit with hot water.
Page 6
All manuals and user guides at all-guides.com
To Replace UV Lamp
The lamp should be replaced whenever it fails to light
during operation. The Zuvo Water Purator uses a high-
intensity ozone generating UV bulb module which
can be obtained from your supplier. For proper unit
operation, use only lamp modules supplied by your
supplier. For your safety and convenience, Zuvo has
designed the lamp to be replaced in a modular fashion.
Simply follow the steps below:
1. Always unplug the
unit before servicing.
Failure to do so can
result in exposure to
harmful UV light.
2. Using the plastic
screwdriver, break the
paper label at the 'X'
and unscrew the
single screw.