Urmet 1092/218 Manual Del Usuario página 32

AUTO
this option selects the camera automatic switching mode from color to black/white, without the
synchronized use of infra-red lighting. This mode can only be used with slow light change. THE USE OF
THIS OPTION IS NOT RECOMMENDED.
Select AUTO to access the following submenu – NOT OPERATIVE:
D-N LEVEL
D-N DELAY
N-D LEVEL
N-D- DELAY
RETURN
Option
D-N LEVEL
D-N DELAY
N-D LEVEL
N-D DELAY
RETURN
DPC (Dead Pixel Compensation – damaged pixel compensation)
This function allow to repair CCD single pixels under low light condition, reducing the brightness of the too
bright pixels.
Press the button "ENTER", the message "Cover the lens then press Enter key" will be displayed. Cover the
lens with a black lid to prevent light from passing through.
Make sure the image is totally dark and not to cover the light sensor (CDS), in order the leds are not turned
on (if leds are turned on, they become red).
Press again the button "ENTER", the message "Processing now....." will be displayed and the
compensation process will start. After few seconds, the menu will go back to the previous level. If the
camera doesn't go back to the previous menu level (because it has not been totally darkened or because
leds were on), switch off and switch on the camera and repeat the operation.
32
All manuals and user guides at all-guides.com
D&N AUTO
■■■■■■█■■■033
5 SEC
■■■■■■■█■■156
5 SEC
RET
Value
It determines the level of "noise" for the Day to Night
000 ÷ 240
switching
1 ÷ 30 Time delay of the Day to Night switching
It determines the level of "noise" for the Night to Day
000 ÷ 255
switching
1 ÷ 30 Time delay of the Night to Day switching
/ It allows to quit the submenu.
Description
DS1092-133