Residual Risks; Package Contents - DeWalt DWE46150 Traducido De Las Instrucciones Originales

english
• Regularly clean the power tool's air vents.
The motor's fan will draw the dust inside
the housing and excessive accumulation of
powdered metal may cause electrical hazards.
• Do not operate the power tool near
flammable materials. Sparks could ignite
these materials.
• Do not use accessories that require liquid
coolants. Using water or other liquid coolants
may result in electrocution or shock.
• DO NOT use wire brushes with this surface
grinding shroud.
• DO NOT use abrasive wheels.
• DO NOT grind or cut metal with a diamond
cup wheel. Fragments could loosen and fly
apart.
• ALWAYS use with a dust collector.
WARNING: ALWAYS use safety
glasses. Everyday eyeglasses are
NOT safety glasses. Also use face
or dust mask if cutting operation is
dusty. ALWAYS wear certified safety
equipment.
WARNING: Before beginning
the work, check to determine
the hazard classification of the
dust produced. Use an industrial
dust extractor vacuum of the
appropriate, officially approved
safety class that is in compliance
with your local dust hazard control
regulations.
WARNING: Always wear proper
personal hearing protection. Under
some conditions and duration of use,
noise from this product may contribute
to hearing loss.
CAUTION: When not in use, place
tool on its side on a stable surface
where it will not cause a tripping
or falling hazard. Serious personal
injury may result.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
20
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.

Package Contents

The package contains:
1 Surface grinding shroud
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Dust port
b. Clamp adjusting screw
c. Replaceable brush skirt
d. Brush skirt removal hole
e. Edging door
f. Edging door tab
g. Clamping lever
INTENDED USE
Your concrete surface grinding shroud has been
designed for dust removal of the following: grinding,
leveling and polishing concrete surfaces. It can
remove dust when removing surface paint, epoxy
and glue. Using the appropriate grinder, diamond
grinding wheel and dust extractor vacuum it can
be used to remove the vast majority of static and
airborne dust which without the use of the surface
grinding shroud could otherwise contaminate the
working environment or pose an increased health
risk to the operator and those in close proximity. This
concrete surface grinder should ALWAYS be used
with a dust extractor vacuum designed for concrete
dust removal.