PestWest Chameleon QUALIS Manual Del Usuario página 5

Chameleon
ENGLISH
®
The unit can be wall mounted using only the upper two keyhole fixing points. However, if the wall is of plasterboard,
stud partition etc, we recommend using all four mounting points and suitable plasterboard fixings to ensure the unit
will be securely mounted.
To mount the unit onto the wall firstly open the front cover by lifting outwards from the bottom (Note: when the cover
is opened approximately 45° it will stay open on its own). Next, open the two board retainer tabs at the bottom of the
unit by twisting outwards as shown below
Figure 2 – Board Retainer Tabs
This will allow the sticky board to be removed from the unit by simply pulling the sticky board downwards.
Now remove the upper LED lamp by simply grasping and rotating the lamp 90° until 2 clicks are heard. The LED lamp
may now be withdrawn by sliding it out of the lamp holders.
Fold the board retainer tabs back into their original closed position and close the front cover. Looking at the front of the
unit now you can clearly see the two upper keyhole mounting points. You can now use the unit as a template, place a
spirit level along the top edge of the unit to ensure it is level and then mark off the two fixing points on to the mounting
surface.
Figure 3 – Marking the fixing points (Sticky board & Upper LED lamp removed)
5