Chameleon
ENGLISH
®
REPLACEMENT PARTS
Sticky Board type: 135-000226 (LED 21" STICKY BOARD - PK6)
LED Lamp type: 130-000321 (Quantum X LED 370nm 550mm T5 Shatter-Resistant).
To ensure a safe use and optimum performance only fit the above original parts.
CHANGING THE LED LAMPS
Switch off the machine before servicing. It must be noted that LED lamps are nothing like fluorescent
lamps, failure to disconnect the unit from power when removing or inserting a lamp is likely to
permanently damage the LEDs. This will result in the LED lamp being irreparably damaged.
Switch off the machine before servicing. Open the front cover by lifting outwards from the bottom (Note: when the
cover is opened approximately 45° it will stay open on its own). Grasp and rotate each LED lamp 90° until the 2 clicks are
heard. The LED lamps may then be withdrawn by sliding them out of the lamp holders.
CAUTION – Quantum X LED lamps are powered by Direct Current (D.C.) at one end only, which is easily recognised by
the silver end cap and the printing on the left-hand side (LHS), see figure 5. The D.C. input pins (LHS) require fitting in
the correct polarity, positive (+) and negative (-). Please note that the correct polarity is marked with a + & – symbol on
the Quantum X LED lamp (LHS printing) and the corresponding LED lamp pins must be fitted to the corresponding +
& – symbols on the metalwork, located on the left side of the trap, next to the lamp holders, see figure 5.
Replacing the LED lamps is the opposite procedure to removal. Close the front cover and switch the unit back on.
Figure 5 – Fitting the LED lamps in the correct polarity and orientation
• When fitting the LED lamps ensure the silver end cap is fitted into the left-hand side (LHS) lamp holders, with the +
& – symbols correctly aligned.
• The black non voltage end cap should be fitted into the right-hand side (RHS) lamp holders.
• The LED lamps will not operate in any other configuration.
• The unit will only operate with Quantum X LED 370nm 550mm T5 lamps.
Manufacturer reserves the right to vary model specifications without notice
GUARANTEE
All PestWest units are supplied with a 3-year guarantee (excluding LED lamps and sticky board).
7