Basic Operation - Silvercrest SKMP 1300 D3 Instrucciones Breves

1. Place the lid 2 slightly distorted onto the
blender jug 5.
2. Rotate the lid 2 clockwise until it stops.
The device is now fully assembled.

Basic operation

Functions only when correctly
assembled
The device only works when it is correctly as-
sembled and the drive arm is lowered and
clicked into place.
Overheating protection
The device has an overheating protection
system. If the motor becomes too hot, the de-
vice automatically switches itself off.
Switching the device on/off
and selecting speed
1. Switch the device on by turning the
speed control 12 to the right.
2. Start at a slightly lower speed, and
slowly increase to the desired speed.
3. Reduce the speed to 1 - 2 when you are
adding ingredients during operation
through the filling opening 10 or the re-
fill opening 3.
4. Set the speed control 12 to 0 to switch
the device off.
Turbo button
• By pressing the Turbo button 13 you
can briefly increase the speed to the
highest setting (10).
Dismantling the device
Disassembly is described in detail in the on-
line instructions.
Cleaning
Disconnect the mains plug 14 from the wall
socket before each cleaning.
Never immerse the base unit 17 in water.
For additional information on clean-
ing and looking after the device and
accessories, please see the online
user instructions.
Disposal
Packaging and device must be disposed of
according to the environmental regulations
of your country.
Trouble-shooting
If your device fails to function as required,
please read the corresponding chapter in
the online user instructions.
19
GB