Mounting Location - Tecma Nano ECO Manual De Uso

Fig. E
IF NEEDED-8" above
waterline ALL TIMES!
K
Floor-minimum 3/4"
A. Fresh Water Hook-up
K1
B. Wiring Harness
K3
C. Bezel (Fig. F)
K4
D. Wall Switch
K5
Thetford Water Pump (Raw Water Install)
K6
Raw Water Pump Hook-Up
K8
E. Lower Discharge Check Valve (Vertical)
#4
Before starting the installation, consider and plan for the following:

Mounting Location

■ Ideally, the Nano Eco toilet should be installed in a location that is higher than the holding tank. A (maximum) 6' rise between the
toilet and holding tank will not impact performance.
■ Using toilet and supplied template, verify that the installation site has:
• suffi cient clearance between toilet and nearby wall so that water supply hose and discharge hose are not kinked
• room for maintenance accessibility
■ The fl oor supporting the toilet is level and strong enough to support toilet and weight of any potential user.
■ The fl oor structure is strong enough to securely anchor toilet using supplied screws; 3/4" minimum.
■ The fl ooring is water-resistant so structure and anchoring integrity are maintained.
www.thetfordmarine.com
Orientation
D
C
G
K6
OR
B
A
A1
A. Filter or Strainer (Raw Water Install)
A1
A
B. Water Tank (Fresh Water Install)
B
C. Non-Thetford Water Pump (Raw Water
Install)
Fresh Water Pressure Pump (Fresh Water
B1
Install)
C
D. 3/4" Water Supply (Raw Water Install)
C1
E. 1/2" Water Supply (Fresh Water Install)
D
F. Vented Loop
15
K5
K4
K3
K8
E
F
4
H
C1
B1
I
E
A. Toilet Discharge Hose
F
B. Relay Module
G
C. Water Pump Wiring (Fig. B)
H
D. Discharge Line (above or below fl oor)
I
E. Holding Tank
J
F. Boat/Craft 12V DC Power Source
G. Mimimum 3/4" fl oor
K
Tecma Nano ECO Owner's & Installation Manual
K1
J
H
Fresh Water Install