Kohler K-11550 Guia De Instalacion página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com
Install the Drain (cont.)
Insert the short end of the rod into the seal hole and under the
stopper. Loosely secure in place with the rod nut.
Push the rod down to open the drain.
Insert the stopper into the drain assembly.
Remove and adjust the stopper so it lifts approximately 3/8" (1
cm) when opened. To adjust, hold the stopper bolt and turn the
stopper counterclockwise to raise and clockwise to lower.
Reinstall the stopper.
For Vandal-Resistant Installations: Remove the rod nut. While
the stopper is in place, insert the end of the rod through the hole
in the stopper bolt. Secure the rod with the rod nut.
For All Other Installations: Tighten the rod nut to secure the rod.
Identify the best hole in the link to allow full operation of the rod
and the lift rod.
Align the link hole with the rod and slide the clip and the link
onto the rod with the thumbscrew facing the back of the lavatory.
To move the link to the proper position, squeeze the clip and
slide it along the rod.
Align the link with the faucet lift rod and push the lift rod
through the hole in the link. If required, loosen the thumbscrew
on the link.
Verify that the lift rod knob rests on the escutcheon when the
drain is in the full open position.
Tighten the thumbscrew to secure the lift rod position.
Kohler Co.
5
1060640-2-A

Publicidad

Tabla de contenido
loading

Tabla de contenido