Access Points - Nokia N Serie Manual Del Usuario

Access points

You may receive access point settings in a message from a
service provider. See "Data and settings," p. 85. Some or all
access points may be preset for your device by your service
provider, and you may not be able to change, create, edit,
or remove them. indicates a protected access point.
indicates a packet data access point, and
access point.
Tip! You can create internet access points in a WLAN
with the WLAN wizard. See "WLAN wizard," p. 26.
To create a new access point, select
access point.
To edit the settings of an access point, select
Edit. Follow the instructions from your service provider.
Connection name—Enter a descriptive name for
the connection.
Data bearer—Select the data connection type.
Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with
Must be defined or with a red asterisk. Other fields can be
left empty, unless you have been instructed otherwise by
your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
116
All manuals and user guides at all-guides.com
Packet data access points
Follow the instructions from your service provider.
Access point
from your service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
a WLAN
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Options > New
Authentication—Select
Homepage—Depending on the access point you are setting
Options >
up, enter the web address or the address of the multimedia
messaging center.
Select Options
following settings:
Network
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address
your device.
DNS address—In
of the primary DNS server. In
enter the IP address of the secondary DNS server. Contact
your internet service provider to obtain these addresses.
name—You obtain the access point name
Normal or Secure.
> Advanced settings to change the
type—Select the internet protocol type to use:
(for IPv4 only)—Enter the IP address of
Primary DNS address, enter the IP address
Secondary DNS address,