Worx Professional WU507 Manual Del Usuario página 9

Working hints for your cordless
reciprocating saw
Always use a blade suited to the material and material thickness to
be cut. The quality of cut will improve as the number of blade teeth
increase. Always ensure the work-piece is firmly held or clamped to
prevent movement. Support large panels close to the cut line. Any
movement of the material may affect the quality of the cut. The blade
cuts on the upward stroke and may chip the uppermost surface or
edges of your work piece when cutting, ensure your uppermost
surface is a non-visible surface when your work is finished.
1. I CANNOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in one direction. Turn
the battery around until it can be inserted into the slot, the red LED
light should turn on when the battery is charging.
2. REASONS FOR DIFFERENT CHARGING TIMES.
Your charge time can be affected by many reasons which are not
defects in your product. If the battery pack is only partly discharged
it may be re-charged in less than 1 hour. If the battery pack and
ambient temperature are very cold then re-charging may take 1-1.5
hours. If the battery pack is very hot it will not re-charge because the
internal temperature safety cutout will prevent it. If the green light is
illuminated but the red light will not illuminate and the battery pack is
hot then this will be the problem and NOT a defect. You must remove
your battery pack from the charger and allow your battery pack to cool
first to ambient temperature and then re-charging can be started.
All manuals and user guides at all-guides.com
9
If you charge a second battery pack immediately after the first then
the charger can be overheated. Always allow at least 15 minutes rest
between battery pack charging.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING
TIMES.
Charging time problems, as above, and having not used a battery pack
for a prolonged storage will reduce the battery pack working time.
This can be corrected after several charge and discharge operations by
charging & working with your saw. Heavy working conditions such as
cutting into hard wood will use up the battery pack energy faster than
lighter working conditions. Do not re-charge your battery pack below
0 C and above 30 C as this will affect performance.
o o
Maintenance
Remove the battery pack from the tool before carrying out any
adjustment, servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.