LG WM9500H Manual Del Propietário página 51

Problem
The tub does not
rotate or
The door is not secured.
Water in the washer Drain hose is kinked, pinched,
drains slowly or not or clogged
at all and
Drain discharge is more
than 96 inches (2.4 m) above
bottom of washer.
Control error.
Water level is too high due to a
faulty water valve.
The water level sensor is not
working correctly.
A motor error has occurred.
If the washing machine detects
too many suds, it displays
this error code and adds a
Suds Reducing cycle. This
adds about 2 hours to the
cycle time. If too many suds
are detected during spinning,
the washing machine stops to
help prevent leaking.
The water level too low or high
compared with the size of the
load.
All manuals and user guides at all-guides.com
Possible Cause
Close and secure the door. If the message keeps
appearing, unplug the power cord and call for service.
Make sure the drain hose is free of clogs, inks, etc., and
is not pinched behind or under the washer.
Use the drain 96 inches (2.4 m) above the bottom of the
washer.
Unplug the washer and wait 60 seconds. Reconnect
power and try again. If the error reappears, call for
service.
Close the water faucets, unplug the washer, and call for
service.
Close the water faucets, unplug the washer, and call for
service.
Allow the washer to stand for 30 minutes and then restart
the cycle. If the LE error code persists, call for service.
Do not add more than the manufacturer's recommended
amount of detergent.
The water level sensor ir not working correctly. Unplug
the powercord and call for service.
TROUBLESHOOTING
Solutions
51