Mig/Mag Welding Setup - Saf-Fro AIR LIQUIDE PRESTOMIG 200MP Instrucciones De Uso Y Mantenimiento

EN

5 - MIG/MAG WELDING SETUP

Press the mode button till the MIG/MAG Welding Screen is viewed on
1
the display.
Unit can be set for working in two different modes:
Normal MIG
■
Synergic MIG
■
Follow carefully the following instructions paying particular attention to the
pictures.
1
MIG/MAG Function Setup Key
In MIG/MAG mode press the setup key
screen.
Use the setup key to run through the parameters and adjust their
5
values by turning the right setting knob
All parameters modification will be validate only after the beginning of
welding.
1
4
Unit ready for NORMAL MIG/MAG welding, voltage
and wire speed are adjustable.
Unit ready for SYNERGIC mode welding.
Trigger Mode:
Selection of the 2 strokes / 4 strokes / spot welding
mode.
Spot Time:
Adjustable only when Spot Welding Mode is set:
regulation of the maximum duration of the Spot
Welding Time (0-10 sec).
MIG/MAG WELDING SETUP
5
to enter the parameters change
5
.
7
5
6
7
Once a Synergic Curve is selected, Slope, BBT and Inductance settings
go back to their default values.
8 - EN
Slope Up:
Adjustment of the time the wire needs from the
striking speed to the welding speed (0 -1.50 sec).
BBT "Burn Back Time":
Adjustment of the length of the wire protruding from
the torch at the end of welding (1-10).
Inductance:
Adjustment of the electronic inductance value (0
-11):
- Low Value = more spatters
- High Value = less spatters
Post Gas:
Adjustment of the gas outflow time at the end of
welding (0 – 5 Sec.).
HOT-START: (trigger mode: 2 strokes)
Percentage of increase of welding current to make
start easier (100 - 140%).
Duration of the welding current slope down (0,2 - 2s).
Hot-Start time.
HOT-START and CRATER FILLER:
(trigger mode: 4 strokes)
Percentage of increase of welding current to make
start easier (100 - 140%).
Percentage of reduction of the welding current
during the crater Filler (30 - 100%).
Duration of the welding current slope down (0.2 –
2 s)
6
SAVE / RECALL key :
Use this key to save and recall the points that the
operator can customize. Refer to paragraph 5.3
4
MATERIAL Key :
Manual MIG/MAG (synergy OFF):
Adjustment of the electronic inductance.
Synergic MIG/MAG (synergy ON):
Access to the screen for the synergic program
adjustment.