Drain System; Important - Whirlpool WETLV27HW Instrucciones De Instalación

Drain System

Drain system can be installed using a floor drain, wall standpipe,
floor standpipe, or laundry tub. Select method you need.
Floor standpipe drain system
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gallon (64 L) per minute. Top of
standpipe must be at least 39" (991 mm) high; install no higher
than 96" (2.4 m) from bottom of washer/dryer. If you must install
higher than 96" (2.4 m), you will need a sump pump system.
Wall standpipe drain system
See requirements for floor standpipe drain system.
10
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number
285834), two Connector Kits (Part Number 285385), and an
Extension Drain Hose (Part Number 285863) that may be
purchased separately. To order, please see toll-free phone
numbers in your Use and Care Guide. Minimum siphon break:
28" (710 mm) from bottom of washer/dryer. (Additional hoses
may be needed.)
Laundry tub drain system
Minimum capacity: 20 gallon (76 L). Top of laundry tub must be
at least 39" (991 mm) above floor on 27" (69 cm) models, or
34" (864 mm) above floor on 24" (61 cm) models; install no higher
than 96" (2.4 m) from bottom of washer/dryer.
IMPORTANT: To avoid siphoning, no more than 4.5" (114 mm) of
drain hose should be inside standpipe or below the top of wash
tub. Secure drain hose with plastic strap.