Electrical Requirements, Gas Models (27" (69 Cm) Models Only); Gas Supply Requirements,Gas Models (27" (69 Cm) Models Only); Gas Supply Line - Whirlpool WETLV27HW Instrucciones De Instalación

Electrical Requirements,
Gas Models (27" (69 cm)
Models Only)
This washer/dryer is equipped with a power supply cord
Ƀ
having a 3-prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
Ƀ
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating
outlet is not available, it is the personal responsibility and
obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
If codes permit and a separate ground wire is used, it is
Ƀ
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
Ƀ
Check with a qualified electrician if you are not sure the
Ƀ
washer/dryer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
Ƀ
120 V, 60 Hz AC only, 15 or 20 A fused electrical
Ƀ
supply is required. A time-delay fuse or circuit breaker is
recommended. It is also recommended that a separate
circuit serving only this washer/dryer be provided.
Gas Supply Requirements,
Gas Models (27" (69 cm)
Models Only)
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 13" (330 mm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
GAS TYPE
Natural Gas:
This washer/dryer is equipped for use with natural gas. It is
certified by UL for use with propane gas with appropriate
conversion.
Your washer/dryer must have the correct burner for the type
Ƀ
of gas in your home. Burner information is located on the
rating plate in the door well of your dryer. If this information
does not agree with the type of gas available, contact
your dealer or call the phone numbers referenced in the
"Assistance or Service" section of your Use and Care Guide.
Propane Gas Conversion:
IMPORTANT: Conversion must be made by a qualified
technician.
No attempt shall be made to convert the appliance from the gas
specified on the model/serial rating plate for use with a different
gas without consulting your gas company.

GAS SUPPLY LINE

Option 1 (Recommended Method)
Flexible stainless steel gas connector:
If local codes permit, use a new flexible stainless steel gas
Ƀ
connector (Design Certified by the American Gas Association
or CSA International) to connect your dryer to the rigid gas
supply line. Use an elbow and a 3/8" flare x 3/8" NPT adapter
fitting between the stainless steel gas connector and the dryer
gas pipe, as needed to prevent kinking.
Option 2 (Alternate Method):
Approved aluminum or copper tubing:
Must include 1/8" NPT minimum plugged tapping accessible
Ƀ
for test gauge connection, immediately upstream of the gas
connection to the dryer.
1/2" IPS pipe is recommended.
Ƀ
13