Tecno-gaz STERILAIR PRO Manual Del Usuario página 42

 The Skip Function only intervenes until it reaches the subsequent programmed
switching point. At this point the Skip Function is cancelled and the programmed
switching cycles are activated once again.
Programming Errors
If "EEE" appears, there is a setting error. The number of the switching cycle with the error
is displayed.
Move the setting switch to P.
Press the button until it displays the cycle with the error. Correct it and then move the
setting switch to "RUN" to exit the programming mode.
Every switch‐on point is linked to the subsequent switch‐off point. Therefore the following
ON/OFF combinations can, for example, lead to errors.
Possible causes of errors:
Activation ON
a) Programmed switch‐on
b) No setting
c) Day block (e.g. 1, 2, 3, 4, 5)
d) Day block
e) Programmed time activation
(e.g. Wednesday, 09:00)
f) Switch on and off set at same times (e.g. Wednesday, 09:00)
Technical Data of programmer
 Daily and weekly programming of 16 switches per channel (8 x ON, 8 x OFF). With day
block programming, there are 56 switch possibilities.
 The minimum time interval between switching points is 1 minute.
 Lithium battery (3Vdc) lasting up to 5 years without power supply.
 Ambient temperature: ‐10°C to +55°C (T‐10; T55).
Deactivation OFF
No setting
Programmed deactivation
Different day block (e.g. 1, 2, 3, 4, 5,6)
Day of the week
Deactivation of the set time is prior to the
activation time on the same day (e.g.
Wednesday, 08:59)
15
ENGLISH