How To Change The Bag; Liquids Vacuuming; At The End Of A Cleaning Session - Nilfisk S2 L Manual De Instrucciones

How to change the bag

WARNING!
■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■ Take care not to raise dust during these
operations. Wear a P3 protective mask.
In case of dangerous and/or toxic dust, you must
■
use the supplied safety bag for these certified
vacuum cleaners.
■ The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
WARNING!
Installing the wrong paper bag for the class of dust
to be vacuumed or incorrect installation, can create a
health risk for the persons exposed.
How to replace the Dust Bag for class M vacuum cleaners
(Fig. 11)
■ Close the inlet by using the relevant cap (1).
■ Release the dust container.
■ Remove the Dust Bag and close it with the relevant cap
as shown in figure 11.
■ Insert a new bag, making sure the bag inlet is sealed.
■ Replace the dust container in the vacuum cleaner.
WARNING!
Only use suitable bags for the vacuum cleaner class
you are using.
How to replace the Safe Bag for class H vacuum cleaners
(Fig. 12)
■ Remove and put the vacuum hose in a safe and dust-
free place.
■ Close the inlet by using the relevant cap (1).
■ Release the dust container.
■ Close the Safe Bag by pulling the "guillotine" (2) seal.
■ Close the plastic bag hermetically using the relevant
band (3).
■ Use the sticky tape (4) to close the bottom of the plastic
bag.
■ Remove the relevant connection (5) of the bag from the
inlet.
■ Insert a new safe bag, making sure the bag inlet is
sealed.
■ Wrap the plastic bag around the dust container external
wall.
■ Replace the dust container in the vacuum cleaner.
WARNING!
Only use suitable bags for the vacuum cleaner class
you are using.
01/2015
S2 / S3 / E-VAC2000 / BDC1330

Liquids vacuuming

WARNING!
Make sure that the vacuum cleaner is equipped with a
liquid level sensor and is suitable for vacuum liquids.
■ The filter element will be wet after liquids have been
vacuumed.
A wet filter element can quickly become clogged if the vacuum
cleaner is then used to vacuum dry substances.
For this reason, make sure that the filter element is dry or
replace it with another one before using the vacuum
cleaner for dry materials.

At the end of a cleaning session

■ Turn the vacuum cleaner off with switch (1 - Fig.5) and
disconnect the plug from the socket.
■ Wind the connection cable up and hang it in the relevant
compartment (Fig. 13).
■ Empty the container as described in the "Emptying the
container" paragraph.
■ Clean the vacuum cleaner as described in the paragraph
"Maintenance, cleaning and decontamination".
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized persons.
■ Close the inlet with the appropriate plug (1, Fig. 13) when
the vacuum cleaner is transported or is not being used
(particularly in the case of M, H) versions).
9
GB
C343