Air Purifier Controls; Turning On/Off; Filter Change Indicator - Filtrete FAP-C01BA-G1 Manual De Instrucciones

AIR PURIFIER CONTROLS

This Filtrete™ room air purifier uses advanced new electronic controls with a "soft touch"
operation. When you press the printed icon for each function, the controls will sense your
touch and the air purifier will respond.

Turning On/Off

Plug the air purifier into a 120V AC electric outlet, then press the POWER icon to turn
ON the device. To turn the air purifier OFF, simply press the power button again.
Adjusting Fan Speed
This air purifier has 3 fan speeds – a higher fan speed will provide a higher level of
cleaning. Press the FAN icon to cycle through the available fan speeds (1-3). Press
the icon again to return to fan speed 1.
Timer
The timer function will turn the air purifier OFF after a set amount of time.
For example: 2h will turn off after 2 hours of operation.
To start a timer, press the TIMER icon until you reach the desired time. Press the
TIMER icon again to cycle through the timer settings, or turn the timer OFF (timer
setting lights will turn off).
Lighting Function
This air purifier has a light function that will turn all the display lights off for 12 hours
to avoid bright lights while you sleep. This setting will not affect the fan speed or
timer of the air purifier.
To temporarily turn OFF the display lights, simply press the LIGHT icon on the air
purifier. To turn the display lights back on, press the LIGHT icon again.

Filter Change Indicator

This air purifier is equipped with an electronic filter change indicator. This indicator
monitors the use of the filter to signal when the filter needs to be changed. The
indicator light will turn on in an orange color when the filter has 10% life remaining. The
light will then turn red when the filter life is 0% and the filter should be changed. The
table below provides an estimated length of filter life based on the number of hours of
daily use (in a 7-day week). Once you have changed the filter in the air purifier, reset
the filter change indicator – to do so, hold the RESET icon for 3 seconds.
9