Polk ATRIUM SAT300 Manual Del Usuario página 5

PENDANT MOUNT
To pendant mount the SAT300, you will
need the following hardware:
• SAT300 Loudspeaker
• Eyebolt (with nut)
• (1) .25" split ring lock washer
• Two faston connectors
• Pendant cable (not included)
• Loudspeaker wire (not included)
• Pendant cap
Eyebolt
Nut
Lock washer
Pendant
cap
Cabinet
Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: +1 410-358-3600)
Pendant
cable
Instructions:
Note: A pendant cable (not included)
is required to hang the Atrium SAT300
loudspeaker from a ceiling or overhead
beam. Use a cable that meets or exceeds
the safety and/or building codes applicable
to the mounting situation. The speaker
weighs 3.5 lbs. on its own.
1. Determine how far down from your
ceiling or beam you want your
loudspeaker to hang.
2. Secure the pendant cable to the ceiling or
beam and run loudspeaker wire along the
pendant cable.
3. Attach the supplied faston connectors to
the loudspeaker wires.
(Large = "+", Small = "–")
Customer Service Hours of Operation: Monday-Friday 9AM-6PM EST
4. Expose the loudspeaker spade terminals
on the back of the cabinet by removing
the knob, clamp and bracket.
5. Disconnect the existing loudspeaker
wire from the spade terminals using
needle-nose pliers and remove the
bracket assembly.
6. Thread the new speaker wire through the
wire hole in the pendant cap and connect
the wires to the loudspeaker spade
terminals, observing correct polarity.
7. Attach the pendant cap to the speaker
using the eyebolt, lock washer and nut.
8. Secure the pendant cable to the eyebolt.
Caution: Secure mounting is required to
prevent personal injury or damage to
the speaker.
polkcs@polkaudio.com