Battery Runtime; Dimmer Curves - Cameo ZENIT B60 Manual De Usuario

AC Failure = Operating status with mains fault
Dimmer Curve = Dimmer curve
Dimmer Response = Dimmer sensitivity
Color Calibration = Colour calibration
Autolock = Automatic locking of the controls
IR Remote = Activates / deactivates functionality of IR
remote control
Wireless Setting = W-DMX settings
(Wireless-DMX)
Factory Reset = Reset to factory setting
Confirm all entries with ENTER.

BATTERY RUNTIME

The battery runtime can be extended to up to 24 hours by reducing the brightness (see Settings table). Here runtime is calculated based on
Full On and 100% battery charge status. Runtime is significantly extended when not all colours – red, green, blue and white – are activated
(Full On) but only, for example, red.

DIMMER CURVES

linear
DMX value
exponential logarithmic
DMX value
DMX value
No Action Lamp switches to battery operation in
the same operating mode
Blackout Lamp changes to blackout
Emergency Light Lamp changes to colour macro "Cold
White" with battery operation
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted at
lower DMX values and broadly adjusted
at higher DMX values.
Logarithmic Light intensity can be broadly adjusted
at lower DMX values and finely adjust-
ed at higher DMX values.
S-Curve Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
LED Lamp responds abruptly to changes in
DMX value
Halogen Lamp behaves like a halogen spotlight
with soft brightness changes
Red, Green, Blue, Individual colour calibration. Cross-
White mode brightness setting of the 4
LED groups RGBW with values from
000 - 255
On Automatic locking of the controls after
approximately 1 minute of inactivity.
Display in the display after the operat-
ing test: "Locked!"
To unlock: Press and hold UP and
DOWN simultaneously for approx. 5
seconds
Off Automatic locking of the controls is
disabled
On Functionality is activated
Off Functionality is deactivated
Receive On/Off On = W-DMX enabled
Off = W-DMX disabled
Receive Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
Reset to factory settings:
ENTER -> "Reset Now!" -> ENTER
S-curve
DMX value
11