Dmx Mode - Cameo ZENIT B60 Manual De Usuario

DMX MODE

Seven different DMX operating modes are available for selection: 2CH, 3CH, 4CH, 8CH 1, 8CH 2, 10CH and 15CH. Select DMX mode as
previously described in SETTING OPERATION MODE and confirm with ENTER. Using the UP and DOWN controls, select the desired DMX
mode (observe arrow), confirm again with ENTER and press MODE twice to return to the main display. Tables with the channel assignments
can be found in these instructions under DMX CONTROL.
---------------- Mode ----------------
DMX
Slave
Auto
SLAVE MODE (Slave)
Repeat procedure as described previously in SETTING OPERATION MODE. Press MODE to return to the main display (slave mode).
---------------- Mode ----------------
DMX
Slave
Auto
Connect the slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master unit (Auto,
Static, Colour Macro). Now the slave unit will follow the master unit. If there is no control signal, the display characters will flash. Flashing
stops as soon as a control signal is present.
AUTO MODE (programme 1 - programme 6)
The 6 different auto-programmes each comprise non-editable colour-change sequences. Brightness and speed are independently adjustable.
Select auto mode as per the procedure previously described in SETTING OPERATION MODE and confirm with ENTER. Using the UP and DOWN
controls, now select one of the 6 auto-programmes (observe arrow) and confirm with ENTER. To adjust brightness, use the UP and DOWN
controls to select the menu item "Dim", and confirm with ENTER, then use the UP and DOWN controls to select the desired value between 000
and 100. Confirm with ENTER. Set the run speed by selecting the menu item "Speed", confirm with ENTER, and then select the desired value
between 000 and 100. Confirm with ENTER. Press MODE four times to return to the main display (Mode Auto).
---------------- Mode ----------------
DMX
Slave
Auto
STATIC MODE (Static)
The static mode allows the functions Dimmer, Strobe, R, G, B, W and Color Temp to be adjusted directly on the device with values between
000 and 255, in a similar way to with a DMX controller. In this way, an individual scene can be created without an additional DMX controller.
Select static mode as per the procedure previously described in SETTING OPERATION MODE and confirm with ENTER. Using the UP and
DOWN controls, now select the menu item that you wish to edit (observe arrow) and confirm with ENTER. The display will show a three-digit
number field and you can use the UP and DOWN controls to configure the desired value between 000 and 255. Confirm with ENTER. Press
MODE three times to return to the main display (static mode).
---------------- Mode ----------------
Slave
Auto
Static
------------ DMX Mode ------------
15CH
10CH
8CH 2
8CH 1
4CH
3CH
2CH
Mode
Slave
---------------- Auto ----------------
Program 1
Program 2
Program 3
Program 4
Program 5
Program 6
---------------- Static ----------------
Dimmer <255>
Strobe <255>
Red <255>
Green <255>
Blue <255>
White <255>
Color Temp <255>
------------- Program x -------------
Dim <100>
Speed <100>
000
Mode
-
Static
255
001
Mode
-
Auto
100
9