A3Troubleshooting; A4 Bravomax A Disposal - Acqua Brevetti BravoMAX A Serie Manual De Instrucciones

A3TROUBLESHOOTING

Problem
Green led off.
Yellow led on.
Yellow led flashes at a rate of one
flash per second.
Yellow led flashes at a rate of one
flash per two seconds.
Water loss from the drain of the
filter
A4 BRAVOMAX A DISPOSAL
This product falls within the scope of the Directive 2012/19 / EU concerning the management of electrical and
electronic equipment (WEEE).
Electrical and electronic devices must not be considered household waste.
Consumers must return electrical and electronic devices at the end of their useful life to suitable centers
recycling.
Inquire through the municipal authority for the location of ecological platforms to receive the product for disposal and
its recycling. For any further information, contact the manufacturer.
The crossed-out wheeled bin symbol indicates that the product is subject to the disposal regulations established by
Regulations (RAEE). The illegal disposal of the product by the user involves the application of the
administrative sanctions. With the recycling and re-use of the material and other forms of use of obsolete devices we
can make an important contribution to the protection of the environment.
The equipment is not potentially dangerous for human health and the environment, it does not contain harmful
substances as per Directive 2011/65 / EC (RoHs), but if abandoned in the environment impacts negatively on the
ecosystem.
BravoMAX A - ENGLISH
Cause
Tension interrupted.
Defective power supply
Electric circuit out of use.
The filter is carrying outa washing
cycle.
After each washing cycle carried out
the filter remains in a waiting state
for 2 minutes before accepting
another cleaning signal.
Differential stucked.
The command button for manual
washing, placed in the middle of the
carter, between the leds, may be
blocked.
The filter does not carry out the
washing operation because of an
excessive strain
Drain valve tampered with or
blocked.
Drain valve incorrectly positioned.
MAN136 PAG.E-7
Solution
Verify power supply
Substitute the power supply.
Substitute the power supply.
Wait for the cycle to finish.
Allow sufficient time after which
another cleaning cycle may be
carried out.
Shut the water or the by-pass off,
remove the differential feeder
tubes, allow air to escape or blow
with water in order to unblock it.
Check for the carter of the filter to
do not force the black button for
manual washing, placed between
the leds, and in case fix it.
Shut the water off or put the device
in by pass position; refer to the
manufacturer.
Refer to an authorized centre
Acqua Brevetti SRL
Refer to an authorized centre
Acqua Brevetti SRL