Rear-Facing Installation With Latch - Graco ComfortSPORT Manual De Instrucciones

REAR-FACING
1
LATCH belt must be routed through opening in
child restraint for
(see page 29, fig. d).
Belt must lay flat and not be twisted.
2
Adjust child restraint to recline position
(see fig. a and page 25, fig. g) Place
rear-facing on vehicle seat equipped with
LATCH anchors.
3
For ease of installation, extend
maximum length.
4
Hook connectors to vehicle lower anchors
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
5
Press down firmly in center of child restraint
LATCH
while pulling
12
INSTALLATION WITH
rear-facing mode.
LATCH belt to its
adjustment belt. (fig. d).
LATCH
6
Pull front to back and left to right at belt path
to check for secure installation (fig. e). The
child restraint should not move side to side or
forward more than 1 inch (2.5 cm).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service.
7
Check level indicator on child restraint.
Vehicle must be on level ground and child in
child restraint when checking level indicator.
Ball MUST be entirely in green zone (fig. f). If
necessary, place rolled towels under child
restraint, at vehicle seat crease, until entire ball
is in green zone. Then re-check level indicator.
DO NOT use tether rear-facing. Tether must
be stored (see "Tether Storage" page 38).
Perform this test every time you drive with your
child.