Graco ComfortSPORT Manual De Instrucciones página 36

VEHICLE SEAT BELTS
Combination Lap/Shoulder
Belt with Sliding Latch Plate
Pull on latch plate (fig. a). If belt slides freely
through latch plate, a locking clip MUST
be used (see Pg. 37 "Locking Clip" section).
Some combination lap/shoulder belts with
sliding latch plates may be converted into an
"automatic locking mode" that will allow use
without a locking clip. See vehicle owner's
manual and label on vehicle belts for
instructions.
Some Emergency Locking Retractor belts will
convert to Automatic Locking Retractor (ALR)
belts if you pull the belt all the way out. Refer to
your vehicle owner's manual.
Combination Lap/Shoulder
Belt with Locking Latch Plate
The locking latch plate on some seat belts may
slip and loosen after being buckled on child
restraint if positioned at a certain angle. If this
happens, flip the latch plate over (fig. b) and
re-buckle. Test installation again to see if this
works. If not, move child restraint to another
seating position.
36
(continued)
Pull
(fig. a)
Flip
(fig. b)