Function Checks - B.Braun Acculan 3Ti Manual De Instrucciones

Coupling
Abb. 8
Push the attachment onto drill and reamer motor
A until it clicks into position.
Uncoupling
B
Abb. 9
Turn rotating sleeve B in the direction of the arrow
(clockwise when viewed from the rear end of drill
and reamer motor unit A).
Remove the attachment from drill and reamer
motor unit A.
A
A

8.2 Function checks

Note
Function checks must be performed prior to each
operation with the unit and after each intraoperative
attachment or tool change!
Make certain that the attachment is securely
seated.
Make certain that the tool/Kirschner wire is seated
properly.
Briefly run the drill and reamer motor unit, with the
attachment coupled and a tool inserted, at
maximum speed
counterclockwise mode.
Watch out for damage, irregular running noises,
excessive vibrations and excessive heat developed
by the handpieces.
Only use the unit if it is in perfect condition.
in clockwise and
13