Engine Oil; Air Filter - Textron Jacobsen Groom Master II 88008 Manual De Piezas Y Mantenimiento

4.3

ENGINE OIL ______________________________________________________________

Check the engine oil at the start of each day, before starting
the engine. If the oil level is low, remove oil filler cap and add
oil as required.
Diesel Engine:
Perform initial oil change after first 50 hours of operation and
every 75 hours thereafter. See Engine Manual.
Use only engine oils with API classification CD/CE.
Above 77°F (25°C) SAE 30W or SAE10W30/10W40
32 to 77°F (0 to 25°C) SAE 20W or SAE 10W30/10W40
Below 32° (0°C) SAE10W or SAE 10W30/10W40
Gas Engine:
Perform initial oil change after the first 8 hours of operation.
Change oil every 50 hours thereafter.
See the engine manufacturer's Owners's Manual for
detailed service information.
After adding or changing oil, start and run engine at idle with
all drives disengaged for 30 seconds. Shut engine off. Wait
30 seconds and check oil level. Add oil to bring up to FULL
mark on dipstick.
Use only engine oils with API classification SF, SG,SH.
Above 40° F (5° C)
0 to 40° F (-18 to 5° C)
4.4

AIR FILTER _______________________________________________________________

The gasoline powered Groom Master II uses a two stage air
filtration system. The first stage consists of a heavy duty
filter equipped with a filter indicator to alert the operator
when a filter change is required. The second stage,
mounted to the engine includes a pleated paper element
and foam pre-cleaner. Diesel units use only a single stage
heavy duty filter with indicator.
Do not remove the element for inspection or cleaning.
Unnecessary removal of the filter increases the risk of
injecting dust and other impurities into the engine.
When service is required, first clean the outside of the filter
housing; then remove the old element as gently as possible
and discard.
1. Carefully clean the inside of the filter housing without
allowing dust into the air intake.
2. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
3. Assemble the new element and make sure it seats
properly.
4. Reassemble cap making sure it seals completely
around the filter housing. Dust evacuator must be
facing down.
5. Check all hoses and air ducts. Tighten hose clamps.
SAE 30W
SAE 5W30 or SAE 10W30
MAINTENANCE
Diesel Engine Dipstick
Safe Operating Range
Gas Engine Dipstick
4
Figure 4A
Figure 4B
Figure 4C
GB-13