Using the
E
spiralizer
CAUTION
Risk of injury!
Take care when using the
sharp cutting blades and the
tipped spiked disk.
There is a significant risk
of injury.
Touch the blade inserts only
on the plastic surface.
E.1 Setting up the spiralizer
1. Push the storage compartment
[1] and slide [5] out of the guide
of the housing [2].
2. Take the crank [8] and holder [7]
out of the fixing on the back side
and insert the crank into the
opening of the holder.
Position holder [7] on slide [5]
and lock.
3. Place the spiralizer on a smooth,
stable surface and press down
firmly. The device is fixed to the
surface by the suction feet [3].
Fold up mounting frame [4].
Insert slide [5] in the guide of
the housing [2].
14
E.2 Preparing the spiralizer
You can equip the mounting frame
[4] with 3 different blade inserts
[9], [10], [11] and thus achieve dif-
ferent results
(see Fig. on page 3).
1. T aking the blade insert out of
the storage compartment [1]:
Hold the blade insert on the
side recess of the mounting
frame [1a],and pull it out by
a slight lifting function.
2. I nserting the blade insert in the
storage compartment [1]:
Hold the blade insert [10] on
the side on the locking tab [10a]
(the blade points downwards)
and insert in the guide of the
storage compartment. You can
hear the blade insert engaging.
3. T aking the blade insert out of
the mounting frame [4]:
Hold the blade insert on the
recess of the mounting frame
[4a],and pull it out of the guide.
4. I nserting the blade insert in the
mounting frame [4]:
Push the blade insert into the
guide from the side. You can
hear the blade insert engaging.