Noise And Vibration Information; Dust Extraction - Festool OFK 500 Q Manual De Instrucciones Original

2.4

Noise and vibration information

The typical values determined in accordance with
EN 60745 are:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance
Wear ear protection!
Overall vibration levels (vector sum for three
directions) measured in accordance with EN
60745:
Vibration emission level
(3-axis)
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with
other insertion tools or if not maintained adequat-
ely. Take note of idling and downtimes of machine!
3 Power supply and start-up
The line voltage and frequency must correspond
with the data on the ratings plate!
Always switch the machine off before con-
necting or disconnecting the mains lead!
See Fig. 3 for connection and disconnection of the
power cable.
Switch (1.7) serves as an On/Off switch (I = ON,
0 = OFF).
4 Machine settings
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
4.1 Install safety hood
Attach safety hood (1.2) to threaded hole (1.9) in
guiding table (1.1).
The pin (2.6) must rest on the end face
(not on the circumference!) of the ball
bearing guide.
4.2
The setting ring gauge (1.6) is locked using the
sliding catch (1.8):
- Push sliding catch to front = lock setting ring
79 dB(A) gauge,
90 dB(A) - Push sliding catch to back = unlock setting ring
K = 3 dB gauge.
4.3
- Unlock setting ring gauge (1.6).
- Set the required milling depth by adjusting the
setting ring gauge
a < 2,5 m/s2 (turn anticlockwise = decrease milling depth,
h
K = 1,5 m/s² turn clockwise = increase milling depth). Turn-
ing the setting ring gauge by 1 notch increases
or decreases the milling depth by 0.1 mm.
- Lock setting ring gauge.
4.4
- Unlock setting ring gauge (1.6).
- Turn setting ring gauge until the pin (2.4) is op-
posite a notch in the setting ring gauge.
- Press the locking button (2.5) and rotate the
milling tool (2.2), until the locking button en-
gages and therefore locks the spindle (2.3) in
position. Hold down the locking button.
- Undo screw (2.1).
- Remove milling tool (2.2).
- Insert new milling tool.
- Tighten screw (2.1).
- Release locking button and lock setting ring
gauge.
4.5
The machine can be connected to a Festool extrac-
tor using the extraction adapter (1.4).
- Attach extraction adapter (1.4) to extraction
connection piece (1.3) on the safety hood.
- Attach suction hose (Ø 27 mm) to suction adapter.
10
Locking/unlocking setting ring gauge
Do not operate machine unless setting
ring gauge is locked!
Adjust milling depth
Replacing the milling tool

Dust extraction

Always connect the machine to a dust
extractor.