Festool OFK 500 Q Manual De Instrucciones Original página 9

Edge router
Technical data
Wattage
Drive shaft rotating speed
Max. Diameter of milling tool
Weight
Degree of protection
The specifi ed illustrations can be found at the
beginning of the operating instructions.
Symbols
Warning of general danger
Wear ear protection!
Read the Operating Instructions/Notes!
1 Intended use
The OFK 500 Q is intended for fl ush trimming and
profi ling of wood, plastic and similar materials.
The user is liable for damage and injury
resulting from incorrect usage!
2 Safety instructions
2.1 General Safety
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
2.2 Tool-specifi c safety rules
- Hold the power tool by insulated gripping
surfaces only, because the cutter may contact
its own cord. Cutting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
- Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by your hand or against the
body leaves it unstable and may lead to loss of
control.
- Do not operate the machine unless the guiding
table (1.5) and the safety hood (1.2) have been
correctly installed.
- Do not operate the machine unless the setting
OFK 500 Q ring gauge is locked (see chapter 4.2).
450 W - Only use milling tools that are EN 847 certi-
28,000 rpm fi ed for rotating speeds of at least 30.000 rpm.
27 mm Tools that are cracked or misshapen must not
1.5 kg be used.
/ II - Ensure that the milling tool is fi rmly seated and
check that it runs smoothly.
- Only use original Festool accessories.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
2.3
a)
See imprint on tool.
Tool manufactured to comply with EN 847-1.
b)
Type of feed: MAN (manual feed).
Speed: Do not exceed the maximum speed speci-
fi ed on the tool and/or keep to the speed range.
Materials: Wood, plastic.
Warning: The operator is liable for damages and
accidents caused by incorrect use!
c)
Pay attention to the safety instructions included
with your tool.
Pay attention to the safety regulations applicable
on your country.
Do not use tools with noticeable cracks, blunt or
damaged cutting edges ---> danger to live!
The clamping surfaces must be free of dirt,
grease, oil and water.
Clamp the tool so that it cannot come loose dur-
ing work.
Insert the router into the clamping collet as far
as possible or as far as the mark on the router
shank.
Only mill in the opposite direction of rotation of
the tool (counter-rotation).
c)
Use only original Festool spare parts.
Repairs and grinding work may only be carried out
by Festool service centres or qualifi ed experts.
Do not alter the construction of the tool.
Clean tool regularly and remove all resin (use
detergents with a pH value between 4.5 and 8).
Blunt cutting edges can be re-ground to a mini-
mum cutting edge thickness of 1 mm on the
face.
9
Safety instructions Cutter
Technical data
Correct use
Safety instructions
Maintenance and care