Suntec Wellness KLIMATRONIC HEAT WAVE STYLE 1000 Manual De Instruccion página 8

Installation and first use
 Take the appliance out of the packaging and remove the protective
bag.
 If you wish to use the appliance at different locations, mount the
supplied stand leg. Ensure that they are mounted securely with the
provided screws. Then place the appliance on an even, firm and
clean surface, and follow the safety distance between appliance and
other object.
 If you wish to install the appliance at a fixed location, such as a wall,
drill two holes with a difference of 120 mmand insert the dowels.
Insert the screws, so that they protrude about 6 mm. Hang up the
appliance by using the device on the backside.
 CAUTION: Before you attempt to drill holes, make sure that
concerning part of the wall does not contain any wires or cables. Furthermore, all screws should be securely fixed in
the wall and the appliance should be mounted securely! Observe the following safety distances!
 Always place the appliance with a sufficient safety distance to inflammable materials or gases.
 For installation in bathrooms, a minimum safety distance of 60 cm in all directions to all pipe installations, wash
basins, bath tubs and showers is required! Please follow the sketches in section I!
The height of installation on a wall should be between 15 and 30 cm.
 The distance between appliance and ceiling must be at least 50 nun.
 Ensure that housing, heating element, power cord and plug are not damaged.
 Only use outlets with a mains voltage that corresponds to the rated voltage of for appliance. This appliance requires
a voltage of 230V, 50Hz and a current of not more than 15A. Only connect the appliance to an outlet after checking
the voltage.
OPERATING KLIMATRONIC HEAT WAVE STYLE
Item Name
Item Number
EAN-Number
Max. Heating Capacity
Input
 It consists of two switches, a thermostat control, and a power setting switch.
 At first the thermostat control should be turned clockwise to full position. The appliance starts then to warm the
room at maximum power.
The red indicator light shows this visually!
 When the desired room temperature is reached, you can turn the control
back to the position where the appliance tum off (you will hear a "click"
and the green indicator lights up).
OPERATING KLIMATRONIC HEAT WAVE LCD
Item Name
Item Number
EAN-Number
Max. Heating Capacity
Input
Heat Wave Style 1000
11351
4250058311351
1800W
600/1200/1800W
Heat Wave 1000 LCD
11382
4250058311382
1000W
700/1000W
Heat Wave Style 1500
11368
4250058311368
1500W
1000/1500w
Heat Wave 1500 LCD
11399
4250058311399
1800W
600/1200/1800W
Heat Wave Style 2000
11375
4250058311375
2000W
1250/2000W
Heat Wave 2000 LCD
11405
4250058311405
2000W
1250/2000W