24. Installing The Flame Broiler Components - Pit Boss Pro PB1100PSC2 Manual Del Usuario

24. INSTALLING THE FLAME BROILER COMPONENTS

Parts Required:
1 x Flame Broiler Slider (#6)
1 x Flame Broiler Main Plate (#7)
1 x Flame Broiler Adjusting Bar Handle (#11)
1 x Flame Broiler Adjusting Bar (#12)
Installation:
• Insert the Flame Broiler Main Plate into the Main Barrel, right side
first. Rest the Flame Broiler Main Plate on the built-in ledge (on the
inside right) of the Main Barrel that directs grease towards the grease
bucket. Slide the entire piece to the left side, and the two slots on
the Flame Broiler Main Plate will fit into the rounded ledge. The
Flame Broiler Main Plate will sit slightly at a downward angle. Note
illustration 24A.
IMPORTANT: If the flame broiler main plate is on the base of the
barrel, it is installed incorrectly. The flame broiler main plate should
sit at an angle, with the left side sitting higher than the right.
Improper installation of this part may result in damage to your main
grill barrel.
• Place the Flame Broiler Slider on top of the Flame Broiler Main Plate,
covering the slotted openings. Ensure the raised tab is on the left,
to easily adjust for direct or indirect flame when cooking. Note
illustration 24B. Both Flame Broiler parts are lightly coated with oil to
avoid rusting when shipped.
• Next, insert the Flame Broiler Adjusting Bar through the opening hole
on the left side of the Main Barrel. Add the Flame Broiler Adjusting
Bar Handle on the end outside the barrel. Next, slide the notched end
of the Flame Broiler Adjusting Bar into the locking tab on the Flame
Broiler Slider, giving you adjustable access to the Flame Broiler Slider
on the Main Plate. Note steps in illustration 24C.
NOTE: When the flame broiler slider is open and direct flame is used,
do not leave the grill unattended for any period of time.
24A
7
24B
7
6
24C
A
A
11
B
12
B
17