Clean Track 70-2 PUMP AUTOMATIC Manual De Instrucciones página 19

risk to persons and to objects and will compromise the proper
functioning of the machine.
Never let the power cord to pass over sharp angles or edges,

avoid crushing or squashing it, and avoid bringing it into contact
with brushes and/or rotating electrical parts.
Damaged power cords must be replaced by the manufacturer, or

by authorized service centers, or by professionally qualified
personnel.
 In case of leaks (foam or liquids), turn off the machine
immediately.
This machine must be stored indoors only.

The safety floater and its housing must be cleaned and

examined frequently to ensure its integrity.
Do not use the machine if the floating devices are damaged.

Attention
Never close off or block the vacuum air inlet on the
machine or the flexible hose or the attachment completely
during use.
Attention
Ensure that the attachment in use never completely sticks
to the surface being vacuumed, to allow for a passage of
air.
Attention
The installation and use of the machine must be in
accordance with local and national regulations and laws
governing the use of the machine.
If necessary, the designated user must be equipped with
proper personal protection gear (DPI).
After removing from the packaging, check the integrity of the
machine.
Attention
In case of doubt, DO NOT use the machine and contact a
technical service center.
Attachments and filtration systems may be placed inside the tank
for shipping, therefore before using the machine:
 Remove the top (see paragraph 3.A: UNHOOKING THE TOP)
 Remove all components from inside the tank
 Assemble/install all filtration systems necessary for the
type of material being vacuumed (see paragraph 4: USE
AND CLEANING OF FILTRATION SYSTEMS)
3.A- UNHOOKING THE TOP
To remove the top:
• Ensure that the plug is not inserted in the electric socket.
• Pull the lever out,
• Lift the hook,
Remove the top.
•
4.B- FLEXIBLE HOSE ASSEMBLY
To assemble the flexible hose in the vacuum air inlet:
Insert the cuff into the vacuum air inlet until it clicks into
•
position
To remove the flexible hose:
Press the release button and pull out the cuff.
•
3.C- TURNING ON THE MACHINE
To turn on the machine:
• Press the switch to the "I" position (ON).
3. USE
EN
To turn off the motor, press the switch to the "0" position (OFF).
4. USE AND CLEANING OF THE FILTRATION SYSTEMS
Each machine is supplied with a series of filtration systems.
Other optional filtration systems for specific applications are
also available for purchase.
4.A- SUPER FILTRE BAG (OPTIONAL)
Use the filter bag for vacuuming dust and solid matter.
Attention
Do not use the Super filter bag to vacuum sharp or jagged
objects (glass, nails, etc.) or liquid matter.
To assemble:
Place the filter in the waste tank,
•
Insert the flange all the way onto the inner vacuum air inlet.
•
When the filter bag is 2/3 full:
•
Pull out the flange from the inner vacuum air inlet.
•
Close the tab over the entry hole of the filter bag to prevent
•
the waste matter from falling out.
• Dispose of the bag according to the nature of the vacuumed
waste and according to current waste disposal regulations.
Attention
The filter bag is single-use and disposable, must not be
re-used.
4.B- POLYESTER FILTER WITH SUPPORT RING
Without filter support basket
This filter must always be used to vacuum dust and solid matter,
even in the presence of the filter bag.
Attention
Do not use the polyester filter to vacuum sharp or jagged
objects (glass, nails, etc.) or liquid matter.
To assemble:
Place the filter in the waste tank,

Ensure that the filter support ring is positioned correctly on

the tank's rim.
With filter support basket