Depth Adjustment; Safety Switch - Skil 5580 Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SM 1619X05345 03-10:SM 1619X05345 03-10 3/10/10 3:07 PM Page 9

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen
the depth adjustment lever located between
the guard and handle of saw. Hold the foot
down with one hand and raise or lower saw by

SAFETY SWITCH

The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 10.)
FIG. 5
S FETY SWITCH
RELE SE BUTTON
BEVEL ADJUSTMENT
Disconnect plug from power source. The foot
can be adjusted up to 45° by loosening the
bevel adjustment wing nut at the front of the
saw. Align to desired angle on calibrated
quadrant. Then tighten bevel adjustment wing
nut (Fig. 8). Because of the increased amount
of blade engagement in the work and
decreased stability of the foot, blade binding
may occur. Keep the saw steady and the foot
firmly on the workpiece.
Operating Instructions
C LIBR TED DEPTH
BR CKET
Calibrated For Standard
Lumber Sizes
DEPTH
FIG. 3
DJUSTMENT
LEVER
BL DE WRENCH &
STOR GE RE
TRIGGER
the handle. Tighten lever at the depth setting
desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
ONE TOOTH LENGTH SHOULD PENETR TE
WOOD FOR MINIMUM SPLINTERING
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment wing nut, set to 0° on quadrant,
retighten wing nut and check for 90° angle
between the blade and bottom plane of foot with
a square (Fig. 6). If adjustment is necessary, tilt
foot to 45°, tighten bevel adjustment wing nut
and bend "TAB" with an adjustable wrench or
pliers (Fig. 7).
FIG. 6
FOOT
90°
BEVEL
DJUSTMENT
BL DE
WING NUT
FIG. 8
-9-
FIG. 4
FIG. 7
T B
BEVEL
DJUSTMENT
WING NUT
QU DR NT

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5585

Tabla de contenido