Depth Adjustment - Skil 3510 Instrucciones De Funcionamiento

3510 2610008262 ENG:SM 2610008262 12-09 3/26/10 9:03 AM Page 11

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen
the DEPTH ADJUSTMENT LEVER located
between the guard and handle of saw. Hold
the FOOT down with one hand and raise or
lower saw by the handle. Tighten lever at the
depth setting desired. Check desired depth
(Fig. 4).
FOOT
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set
FOOT to maximum depth of cut setting.
Loosen bevel adjustment lever, set to 0° on
quadrant, retighten lever and check for 90°
angle between the BLADE and bottom plane
of foot with a square (Fig. 6).
If adjustment is necessary, loosen the
POINTER ADJUSTMENT SCREW and move
the pointer to the zero (Fig. 6).
FOOT
Operating Instructions
Fig.4
DEPTH
ADJUSTMENT
LEVER
Fig. 6
POINTER
ADJUSTMENT
SCREW
90˚
BLADE
Adjust the cutting depth to the thickness
of the workpiece. Less than 1/2 in. (13 mm)
of the blade should be visible below the
workpiece.
1/2"
BEVEL ADJUSTMENT
Disconnect plug from power source. The
FOOT can be adjusted up to 45° by
loosening the BEVEL ADJUSTMENT NUT at
the front of the saw. Align to desired angle on
the GRADUATED QUADRANT and then
tighten bevel adjustment nut (Fig. 7).
Because of the increased amount of blade
engagement in the work and decreased
stability of the foot, blade binding may occur.
Keep the saw steady and the foot firmly on
the workpiece.
GRADUATED
QUADRANT
FOOT
-11-
Fig. 5
Fig. 7
BEVEL
ADJUSTMENT
NUT