Zamel sundi ST-300P Manual Del Usuario página 3

WIRELESS HERMETIC BELLPUSH ST-300P
MAIN FEATURES
• designed for operating with M series wireless chimes (ALCANO, ALCALINO,
LOOPO, BRILLO, CORNO, VIBRO, SATTINO) and RT-228 retransmitter,
• operating range*: 100 meters (for ALCANO, ALCALINO, LOOPO, BRILLO, CORNO,
VIBRO chimes), 150 meters (for SATTINO chime) in open area,
• bellpush with a circumscription area,
• bellpush designed for work in difficult conditions and changeable weather (e.g. at a
gate).
TECHNICAL DATA
Power supply: battery 3 V type CR2032
Transmission: radio
Frequency: 433,92 MHz
Encoding: 256 codes
Transmission power: ERP< 5 mW
Range*: 100m (for ALCANO, ALCALINO, LOOPO, BRILLO, CORNO, VIBRO chimes),
150 m (for SATTINO chime)
Protective class: III
Protection factor: IP 44
Temperature operating range: from -20°C to +35°C
Dimensions [mm]: 85 x 26 x 32
* The given range concerns opened area i.e. perfect conditions, without obstacles. If between the
transmitter and the receiver obstacles are found, then it can be expected smaller range for: wood
and plaster from 5 to 20%, the brick from 20 to 40%, armed concrete from 40 up to 80%. By metallic
obstacles applying radio systems isn't being recommended from the attention for considerable limiting
the radius. Also overhead and underground power lines have the negative influence on the range of
big power and transmitters of the GSM network put in the walking distance of devices.
BUTTON MOUNTING
• remove the stopper and the plate,
• deflect the catch inside the button, placed under the stopper (fig. 2),
• screw the lower bottom part with screws or fit with two-sided adhesive tape at the
demanded place (the plate should be directed towards the bottom),
• fit the button upper part,
• fit the stopper and the plate,
• check the button operating.
Do not mount the button directly onto a metal substrate, because it may limit the
button operating range.
REMOTE CONTROL REGISTRATION
• remove the remote control battery,
• insert the battery into the remote control container (one of 256 codes will be selected
randomly),
• insert the batteries into the chime container (this way the chime is ready for the
remote control registration),
• push the remote control pushbutton — the remote control will be registered by the
chime.
MELODY / SOUND SELECTION
In order to select required melody / sound press "S" pushbutton placed inside the
remote control, over the battery (Fig. 3). The number of sounds depends on the chime
type.
NOTE! RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY THE WRONG TYPE
OF BATTERY. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
ZAMEL devices marked
with this sign can work
with each other